To turn this good recording into a great one, you can use Logic ‘s Expander or Gate to remove low-level noise between phrases, you can use Compressor to add density and to even out the vocal level, and you can add EQ to fine-tune the tonality of the sound.
Moreover, is the Remove Silence feature in logic all you need?
While editing with Logic’s Marquee/Fade tools and Selection-Based Processing is certainly necessary at times, even in those cases, the Remove Silence feature is a great way to get the ball rolling. However, in many scenarios, it will be all you’ll need. What is the Remove Silence in Logic?
When we were writing we ran into the query “How do I Turn Off sound sensitivity in Logic Pro X?”.
Then just hit Control + X to bring up the feature’s UI. From there, Logic will present you with a visual representation of the audio region selected along with a series of controls for adjusting the degree of silence/noise to be removed. Threshold is how we adjust the sensitivity.
Let’s say you have a singer who sings a few lines much louder than others, and you want to use a compressor to control these differences in volume. Use the loop control in Logic to select a section of vocals, and open up the compressor plugin. Start with a modest ratio of 2:1-4:1 (4:1 is generally seen as the middle ground in compression ratios).
However, in the same way that an attractive person can still enhance their natural appearance with a good haircut and nice clothes, a pristinely captured vocal recording can still benefit from some extra work in Logic Pro: a kind of cosmetic enhancement for the larynx, if you like.
What is the best way to mix in Logic Pro X?
Every engineer, producer or audio enthusiast has their own process for mixing, and there is in no way one best way to mix. There are a few best practices though, and so in this tutorial you will learn about 5 key areas of mixing in Logic Pro X:.
Is there a way to cancel out noise with noise gate?
Using Noise Gate doesn’t work because it can only take it out where there’s no other sounds. Someone once told me there was a way to do it where you could record the noise you want to remove, and then somehow use that to cancel it out from the original audio? Would this work, and if so what’s this method called?
How does logic determine what parts of the audio are kept?
By analyzing a selected audio region’s waveform information and transients, Logic will determine what parts of the audio is to be kept, and which of it is silence (or unwanted noise) to be removed or deleted. Using a series of basic controls, you can influence the way with which that determination is made.